Sells Mendel 201105

Printer Notes

According to http://makergear.wikidot.com/prusa setting for retraction: Plastruder retraction settings: 18mm/m and 1.3mm length According to https://reprap.org/wiki/Volumetric_Dimension_settings setting for extrusion: MakerGear Mendel Prusa kit: 1258 step/mm experimentally found by moving 100mm and 500mm --Affy, May 15th, 2012

Progress on Sells Mendel as of 20120302

Paul Brown printed and installed a new X Carriage. It works fabulously well, and also allows the use of the Budaschnozzle v1.0 hot-end.

Progress on Sells Mendel as of 20111103

Printed and installed the Afterthought Foot.

Mendel 201105

Installed the Makergear Stepstruder at some point last week, and have been testing and calibrating since. It is working great! https://www.makergear.com/products/extruder-motor?variant=21668418500

Mendel 201105

Progress on Sells Mendel as of 20111005/20111006

Getting the Mendel back up and working. Software is working. Firmware is compiled and installed. Heated build platform is working (mostly.) Only thing remaining is getting the extruder working.